View Single Post
  #9 (permalink)  
Old February 17, 2011, 05:24 PM
draemn draemn is offline
Hall Of Fame
F@H
 
Join Date: Dec 2010
Location: Fort St. John, BC
Posts: 1,228

My System Specs

Default

Quote:
Originally Posted by mkultra View Post
i'd like to add this to your "voltages" comments

"auto"
most mobo when raising block will increase voltage in auto mode and most of the time it will end up too high for no reasons.

I would advice anyone to manually set voltage to their default value before starting bumping bclk, and bumping them only when required
Maybe I should note that. In my case, I have monitored voltages to not go above default, but that my be because I have a low o/c. For anything higher (i.e. past 4.0ghz), I always suggest setting each voltage manually, even if you just set it at the default value.

For your second point, I'm showing a 'quick and dirty' method that is much faster than what you suggest. That is why the difference.
Reply With Quote