Thread: Completed MiniITX on Water [Q08+PA160]
View Single Post
  #10 (permalink)  
Old November 17, 2010, 05:31 PM
zoob zoob is offline
Hall Of Fame
F@H
 
Join Date: Aug 2007
Location: Toronto, ON
Posts: 1,024

My System Specs

Default

Very good Q about the pump. I might need to switch to a t-line instead of the XSPC res-top.

Also just ordered:
Seasonic X750 PSU - fully modular, high efficiency, low noise
Primochill LRT tubing 3/8" - clear & black for potential T-line and the rest of the loop. Great seal on 1/2" barbs after steaming the ends.
Enzotech MOS-C1 - for whatever motherboard ends up being used

I'm thinking I might need to find a good quality 140mm fan and fashion some kind of foam shroud instead of using the 120mm shroud. It'd save me about two inches of space, and every bit is going to add up in this build. I knew full well the Q08 would be a difficult one to plan as I never had measurements before I purchased the thing. Let's see how it turns out! :D
__________________
heatware
Reply With Quote