View Single Post
  #2 (permalink)  
Old February 21, 2008, 10:03 AM
MacJunky's Avatar
MacJunky MacJunky is offline
Hall Of Fame
F@H
 
Join Date: May 2007
Location: Creston, BC
Posts: 1,715

My System Specs

Default

To be honest I would advise spinning the blades around with fingers first so you don't get high RPMs tossing anything anywhere because there are other gaps and ways for stuff to seep out.
Personally I would actually remove the blades from the main housing and manually lube up the shaft itself to ensure decent coverage with minimal spillage and dripping and such. I mean, then at least you could get a little rag or something and mix up the graphite with oil then use that to apply further reducing mess.

I don't mean to offend, just my two cents.
Reply With Quote