View Single Post
  #1 (permalink)  
Old February 18, 2008, 05:35 PM
Cptn Vortex's Avatar
Cptn Vortex Cptn Vortex is offline
Hall Of Fame
F@H
 
Join Date: May 2007
Location: Vancouver
Posts: 3,755
Default Bowing the Apogee GT

I'll add pics later, but it is actually very simple, and you don't need to mess around with grease or anything trying to hold the o ring in place.

Basically, just remove the 4 bolts holding the plate on. Then take the old o-ring out, and give the block a little cleaning (water and a toothbrush works fine) I noticed my block had some gunk stuck in the little barbs, needed a cleaning.

Next, you just set the oring around the pins on the base plate. make sure it is Around the pins, and not on top of any of them. Next, you just set the top part of the block onto the bottom, and press firmly. Slowly, with a blunt object of some sort (had a pen lid lying around that worked), work through the gap between the base plate and the top, pushing the rubber o-ring into place all the while squeezing the two parts together. after you get around each side, the ring should be in place, and there should only be a little gap between the sections. Now just put the screws back in, and tighten away! Took me no time at all, literally less than a minute. No fuss, no leaks!
__________________
The Vortex H20

Coolermaster ATCS 840 w Window panel
MSI Z77A-GD65
Intel i7 3770K @ 4.6GHZ 1.28v
Galaxy GTX 680 @ 1241MHZ
8GB Mushkin Blackline 1600MHZ 9-9-9-24 1.5v
Asus Xonar Essence STX
OCZ Z-Series GOLD 850W
2 x 128GB Corsair Force GT SATA3 SSD RAID0 :)
Acheiva Shimian Q270 Lite 2560x1440

Benq W500 Pojector.

Watercooling:
EK Supreme HF, EK FC GTX 680 Block, MCR320+Gelid Silent 12 Push/Pull, DD Pump, EK Multioption 100ml Res, EK Coolstream XT 220 RAD Gelid Wings Push/Pull.
Reply With Quote