View Single Post
  #8 (permalink)  
Old February 7, 2008, 04:46 PM
enaberif's Avatar
enaberif enaberif is offline
Hall Of Fame
 
Join Date: Dec 2006
Location: Calgahree, AB
Posts: 10,658
Default

Quote:
Originally Posted by tzetsin View Post
ok, sounds good :D as always, thanks for the info. a quick side question, is there a "wrong" way to run the fluid through the cpu block? i had it goin one way, but i dont think its cooling quite as good as it should... its only about 10 degrees cooler with water than it was with my zalman
Water vs Air you'll see anywhere between a 10-15 degree difference under load.

So if I'm seeing 70' under load now and went with water I could see temps of 55-60 under load which of course allows me to go further.

But this also depends on pump, rad, block, fluid, fans etc.
Reply With Quote