View Single Post
  #36 (permalink)  
Old February 5, 2008, 08:44 PM
3.0charlie's Avatar
3.0charlie 3.0charlie is offline
3.0 "I kill SR2's" Charlie
Join Date: May 2007
Location: Laval, QC
Posts: 9,933

My System Specs


Originally Posted by zlojack View Post
I was looking at the Micro-res. It would fit my case better, because where I was thinking about putting the drive bay res would conflict with my VGA card.

I'm still a bit confused about the res situation. Could I install the Micro-res with a fillport at the top of the case? Then run a tube from there to the pump. After the pump, a y-junction with a split for a drain and a line to the rad.... then the rest of the loop.

I think I need to get a photo of my case and do some photochopping....

EDIT: I just had a thought... I bet I could fit that radiator in the front part of my Ninehundred under the hard drives and use the front fans to pull the air out...

I might have to sacrifice an optical drive...hmmm... food for thought.

I guess I should start by ordering the rad and components and see if they'll fit. Time to take some measurements.
No need for a fillport when using the Micro-res.
Hydro-Quebec is salivating...
Reply With Quote