View Single Post
  #63 (permalink)  
Old November 30, 2009, 10:39 AM
Mnpctech's Avatar
Mnpctech Mnpctech is offline
Allstar
 
Join Date: Oct 2009
Location: Minnesota
Posts: 810
Default

I hope so! Thank you miggs.

I can't cover up the bullet holes..lol





I used the Dremel with a cutting wheel to emulate impact to the reinforcement panel.


Using Dremel with egraving bit to gouge the other bullet hole under the acrylic. A ventilation hole was added as well.


Round Modders Mesh used as the ventilation grill in the left side panel.


Scotch Weld DP-190 2 part epoxy is used to attach the Modders Mesh to the backside of the side panel
Reply With Quote