Quote:
Originally Posted by sswilson  Any cutting going to be happening, or is it all pretty well going to bolt on?
If you're cutting, don't forget the "measure twice, cut once" rule. :)
Looking forward to seeing your build.
Don't forget to get us some pre-build idle/load temps for comparison. |
No cutting planned, but on the back of my Kandalf case the punch out tabs aren't large enough for the tubing I'm using. So hopefully I will only be drilling larger holes. Also I did some research on my Asus crossfire board and in the bios I can set the priority order for the gfx card slots. Which means I can place the master card in the bottom slot and it will still be considered the master card
. Will get some idle and load temps tomorrow before I start tearing it appart. Oh and of course some before pics.