sswilson's top mount rad + case window mod
View Single Post
September 25, 2007, 06:55 PM
Hall Of Fame
Join Date: Dec 2006
Location: Calgahree, AB
Originally Posted by
Case is aluminum, so no welding.
I suppose I could use rivets, but I much prefer standard screw/bolt with nuts so that I can easily take it apart if required.
I'm going to try out the SS stock tomorrow so we'll see what kind of stability / strength I get and how many I actually need.
What kind of case are you planning on using? I suppose a person could get some form of modders mesh to make a "rad case" if you didn't want to just do a flush top mount.
I haven't done much metal work with aluminum, but depending on the stock, it shouldn't be too hard to do straight bends if you wanted to make a full shroud similar to what you see on a kooldance topmount setup.
Hex screws would look super sharp if it contrasted against a stark silver.
My System Specs
Gigabyte P67 UD3 B3
i5 2500K (Stock)
8GB G.Skill Ripjaws
EVGA FPB 560ti
View Public Profile
Send a private message to enaberif
Find all posts by enaberif