View Single Post
  #3 (permalink)  
Old August 17, 2007, 05:00 PM
3.0charlie's Avatar
3.0charlie 3.0charlie is offline
3.0 "I kill SR2's" Charlie
Join Date: May 2007
Location: Laval, QC
Posts: 9,932

My System Specs


When I used a similar kit (twice), I managed to have the holes in line with the barbs. But looking at your pic, that's impossible, unless you manage to lower the rad a little bit more. If not, I would locate them as high as possible on that mesh. Otherwise, you will have a very short radius for the barb on the left hand side if you don't.

Idea: why not enter / exit from the top of the case? And have the hoses loop back to the barbs? Might be interesting....

Reply With Quote