View Single Post
  #14 (permalink)  
Old August 15, 2007, 02:34 PM
Supergrover's Avatar
Supergrover Supergrover is online now
Hall Of Fame
Join Date: Dec 2006
Location: Okanagan Falls, British Columbia
Posts: 4,389

My System Specs


Originally Posted by enaberif View Post
Incorrect. For a bit the size of a hole saw you will usually need to center punch the middle to allow the bit to stay centered. If you don't have a center punch then you have to drill a series of smaller pilot holes to allow the drill to stay centered and not wander.
Yes and no, I use hole saws on a regular basis, construction worker, yes a pilot hole does help , the key is to not try and go full bore with your speed right out of the gate, ease into it, if it skips all over then you are doing it wrong, acrylic isn't a super hard substance here. Steel or metal will require a pilot hole.
If you really want to do it right throw it into a drill press.

Originally Posted by 3.0charlie View Post
My knuckles are bleeding from fishing through walls a new CAT6 network cable... I found fresh, untapped electrical outlets...
"It's all in the Reflexes"-Jack Burton
Reply With Quote