View Single Post
  #8 (permalink)  
Old August 4, 2007, 10:09 AM
BALISTX's Avatar
Hall Of Fame
Join Date: Feb 2007
Location: Ottawa, ON
Posts: 2,005

Well after putting together my system I will say that almost everything went smoothly. The only issue I had was with the PCI Expansion slot clips. The one I used for the video card came off in my hand and I could not get it back on so I decided to use the old tried and true method of a screw.

To say this case is completely toolless is not true. The hard drive cage does require your to screw the hard drive in place with four screws. However the whole cage does come out easy by using the retention clips on the side. The only issue I had with the retion clips was lining the holes back up but I'll blame that on my poor hand-eye corindation. LOL.
"Though I walk through the shadow of the Valley of Death I shall fear no evil as my C8 Carbine is locked and loaded."

Next Build: E5200 @ 3.6GHz (333x11) | Xigmatek HDT-RS1283 HSF | Biostar TP43D2-A7 | Mushkin Redlines DDR2-1000 @ DDR2-999 5-5-5-12
EVGA 9600 GT 512MB - 650MHz - 1800MHz - 1626MHz | Seagate 'Cuda 250GB 7200rpm SATA2 | Corsair VX550 | CM690 - Custom Atomic Orange Pearl

Reply With Quote