View Single Post
  #9 (permalink)  
Old January 18, 2009, 10:37 PM
KaptCrunch's Avatar
KaptCrunch KaptCrunch is offline
Hall Of Fame
 
Join Date: Feb 2008
Location: Ontario
Posts: 2,922
Default

Quote:
Originally Posted by MpG
The air pressure in the loop doesn't matter. If you still have air bubbles in the loop, you need them to reach the T-line. Make sure the T-line is partly full, then just run the computer until all the air is gone from the main loop. It could take a long time, especially if you have a high flow rate. If you want, you can pinch the tubing near the T-line to slow the water down, and make it easier for the bubbles to go into the T-line.
PINCH THE OUTLET ONLY for cavitation will result if on suction side of pump

and large syringe
Attached Images
 

Last edited by KaptCrunch; January 22, 2009 at 03:02 PM.
Reply With Quote