View Single Post
  #5 (permalink)  
Old January 6, 2009, 11:59 PM
3oh6's Avatar
3oh6 3oh6 is offline
Hardware Canucks Reviewer
 
Join Date: Mar 2007
Location: Edmonton, AB
Posts: 1,052
Default

no problem and sorry again for the mistake...looks like it was all my fault

the above orientation fits fine but it is snug up against the PWM heat sink. you just have to make sure all the fins are sitting as far down as they go and take a bit of care during installation of the fan and housing. in the photos you can see it puts the slightest bit of pressure on the top fin of the PWM heat sink.
Reply With Quote