View Single Post
  #6 (permalink)  
Old December 12, 2008, 05:08 PM
BALISTX's Avatar
BALISTX BALISTX is offline
Hall Of Fame
F@H
 
Join Date: Feb 2007
Location: Ottawa, ON
Posts: 2,005
Default

Thanks guys.

Snafu: I didn't drill out the rivets, I did it as one piece. But if I were to do it again I would. I think my next case I'm going to powder coat the inside.

Enaberif: You can use steel wool and you can use 220 grit sand paper if you feel 80 or 150 gritt is too coarse. I've used 80 grit before and didn't find it too coarse. I would also recommend only using a Scotch Bright pad on plastic parts.

Thanks for catching the error. I meant to put wet sand between coats.
__________________
"Though I walk through the shadow of the Valley of Death I shall fear no evil as my C8 Carbine is locked and loaded."

Next Build: E5200 @ 3.6GHz (333x11) | Xigmatek HDT-RS1283 HSF | Biostar TP43D2-A7 | Mushkin Redlines DDR2-1000 @ DDR2-999 5-5-5-12
EVGA 9600 GT 512MB - 650MHz - 1800MHz - 1626MHz | Seagate 'Cuda 250GB 7200rpm SATA2 | Corsair VX550 | CM690 - Custom Atomic Orange Pearl


[Heatware]
[eBay]
[Rosetta]
BALISTX.com
Reply With Quote